The Power Sense Module (PSM) provides analog current and voltage sensing to your Pixhawk autopilot mounted either on your BlueROV2 or custom marine robotics project. The ArduSub firmware for the Pixhawk supports the Power Sense Module and through QGroundControl will give you visual indications of battery level and current consumption.

This module uses a hall effect current sensor for excellent accuracy at low current draw.

Unlike standard power modules for the Pixhawk, the Power Sense Module will NOT provide 5V power, only sensing abilities. On the BlueROV2, the Pixhawk is powered from multiple sources so this 5V power supply is not needed.





BlueRobotics
Power
Power Sense Module - Marine Thinking
  • SKU: PSM-ASM-R3-RP

Power Sense Module

$110.99
The Power Sense Module (PSM) provides analog current and voltage sensing to your Navigator Flight Controller or Pixhawk autopilot mounted on your BlueROV2 or custom marine robotics project.

    The Power Sense Module (PSM) provides analog current and voltage sensing to your Pixhawk autopilot mounted either on your BlueROV2 or custom marine robotics project. The ArduSub firmware for the Pixhawk supports the Power Sense Module and through QGroundControl will give you visual indications of battery level and current consumption.

    This module uses a hall effect current sensor for excellent accuracy at low current draw.

    Unlike standard power modules for the Pixhawk, the Power Sense Module will NOT provide 5V power, only sensing abilities. On the BlueROV2, the Pixhawk is powered from multiple sources so this 5V power supply is not needed.





    Parameter

    Value

    Electrical

    Max Voltage Input

    25.2 V (6S)

    Max Current Sensing

    100 A (non-continuous)

    Voltage Sense Output

    11.0 V/V

    Current Sense Output

    37.8788 A/V (offset by 0.330 V)

    Output Connector

    Non-insulated spades (S5-3.5SNB)

    Input Connector

    5.5 mm bullet connector

    Physical (Board Dimensions)

    Length

    24 mm

    0.94 in

    Width

    19 mm

    0.75 in

    Height (without header pins)

    7 mm

    0.28 in

    Power Pin Out

    Pin

    Signal

    Volt

    1 (red)

    NOT CONNECTED

    2 (blk)

    NOT CONNECTED

    3 (blk)

    CURRENT

    +3.3 V

    4 (blk)

    VOLTAGE

    +3.3 V

    5 (blk)

    GND

    GND

    6 (blk)

    GND

    GND



    You Might Also Need

    BACK TO TOP