This T200 comes with a slightly shorter cable and a pre-installed cable penetrator and is a drop-in replacement for the thrusters on the BlueROV2. It’s also included in the BlueROV2 Spares Kit.

If you’re looking for the normal T200 Thruster, you can find it here. Also, remember that this thruster needs an electronics speed controller (ESC), like the Basic ESC, to operate. 





BlueRobotics
Propellers
T200 BlueROV2 Spare (with penetrator and short cable) - Marine Thinking
  • SKU: T200-THRUSTER-BROV2-CW-SPARE-R1-RP

T200 BlueROV2 Spare (with penetrator and short cable)

$289.99
This T200 comes with a slightly shorter cable and a pre-installed cable penetrator and is a drop-in replacement for the thrusters on the BlueROV2. It’s also included in the BlueROV2 Spares Kit.

    This T200 comes with a slightly shorter cable and a pre-installed cable penetrator and is a drop-in replacement for the thrusters on the BlueROV2. It’s also included in the BlueROV2 Spares Kit.

    If you’re looking for the normal T200 Thruster, you can find it here. Also, remember that this thruster needs an electronics speed controller (ESC), like the Basic ESC, to operate. 





    • 1 x T200 Thruster w/ Cable Penetrator
    • 1 x Cable Penetrator Nut
    • 1 x Cable Penetrator O-ring
    • 1 x CW or CCW Propeller


    Parameter

    Value

    Performance

    Full Throttle FWD/REV Thrust @ Nominal (16 V)

    5.25 / 4.1 kg f

    11.6 / 9.0 lb f

    Full Throttle FWD/REV Thrust @ Maximum (20 V)

    6.7 / 5.05 kg f

    14.8 / 11.1 lb f

    Minimum Thrust

    0.02 kg f*

    0.05 lb f*

    Electrical

    Operating Voltage

    7-20 volts

    Full Throttle Current @ Nominal (16 V)

    24 Amps

    Full Throttle Current @ Maximum (20 V)

    32 Amps

    Full Throttle Power @ Nominal (16 V)

    390 Watts

    Full Throttle Power @ Maximum (20 V)

    645 Watts

    Physical

    Length

    113 mm

    4.45 in

    Diameter

    100 mm

    3.9 in

    Weight in Air (with 1m cable)

    0.76 lb

    344 g

    Weight in Water (with 1m cable)

    0.34 lb

    156 g

    Propeller Diameter

    76 mm

    3.0 in

    Mounting Hole Threads

    M3 x 0.5

    Mounting Hole Spacing

    19 mm

    0.75 in

    Cable

    Cable Used

    CAB-PUR-3-16AWG

    Cable Length

    0.71 m

    28 in

    Conductor Gauge

    16 AWG

    Installed Penetrator

    WLP-M10-6.5MM-LC


    Note that nominal operation at 12-16 V is recommended for the best balance of thrust and efficiency, though operation at up to 20 V is allowable. Exceeding 20 V is not within the rating and not recommended, please see here for more information.



    You Might Also Need

    Recently Viewed Products

    BACK TO TOP