Enclosure and Connectors (27)

This vent allows trapped pressure to escape from an enclosure after it has been closed. It includes a threaded plug with a double O-ring seal to open and close the vent.

This Binder 770 connector is our standard for tether connections above the water. Some assembly with soldering required for installation.

This Binder 770 connector is our standard for tether connections above the water. Some assembly with soldering required for installation.

The Enclosure Clamp clamps around a 3″ or 4″ Watertight Enclosure for easy mounting on your vehicle.

Terminal Blocks and Hardware for Electronics Tray (4″ Series). Contents 2 x 8-Circuit Barrier Block 2 x 8-Position Barrier Block Jumpers 14 x 2-Position Barrier Block Jumpers 2 x Barrier Block...

The O-ring Flange seals to a tube on one end and to an end cap on the other. These are used with our flat end caps and dome end caps...

This hand-operated vacuum pump allows you to test the seals on a watertight enclosure without getting it wet. The vacuum test doesn’t test at very high pressure, but it does...

The WetLink Cable Splice Kit allows you to connect two cable ends without any messy potting compounds, molds, or curing time. Install WetLink Penetrators, connect the wire ends internally, and...

This spare set of seals is for replacement or use with our WetLink Penetrators. Contains 10 seals.